Large Booster Bath

TOOLS NEEDED: Phillips head screwdriver

The two piece Booster Bath is designed to snap together one time only and is not designed to come apart once connected. Confirm all #13 snaps are in their proper locations before applying firm downward pressure.

Push rubber bumpers into receiving holes at the bottom of each leg.

Attach legs as shown. Note: Make sure that the legs marked with an "A" are located in front of the Booster Bath. Legs marked "B" are design to be attached at the rear.

Push drain hose on as shown. Flip tub upright when complete.

Install 4 mat clips using 8 small screws as shown.

Place leash restraint in T-formation as shown.

Place plastic washers over steel eyehooks. Push eyehook through hole in side wall of tub and screw on the 3 plastic knobs firmly.

Install Shampoo Caddy in rear sidewall of tub.